55.5mm Plastic Gear 85 Teeth (102A) Arduino Board with USB Cable While the software supports TF

While the software supports TF card drivers to support FAT16

Simply connect the module to the positive and negative contacts of your battery or battery pack

simplifying the design of the switch-mode power supply

These are Metal Film Resistor with a value of 7

The other end of the cable is compatible with the U

55.5mm Plastic Gear 85 Teeth (102A) Arduino Board with USB Cable While the software supports TFThis gear has 85 teeth and an outer diameter of 55. 5 mm. It has a 6. 2 mm diameter central hole. Fits all of our 6. 2 mm axles perfectly. This is a high quality plastic piece of equipment. Use it to get your motor to run at the desired speed and torque. It comes with a set screw that allows it to be easily attached to various diameter motors and axles. Specification Material Plastic gear with a metal shaft Outer Diameter 55. 5mm Number of Teeth 85