MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal while allowing more airflow than

while allowing more airflow than two separate layer filters (flow bench proven) Twin Air filters are slightly smaller than stock to make them easier to change and to increase dead air space around the filter for better performance

Merged the 1-7/8" head pipes into a large 2-1/4" collector that steps up to a 2-1/2" perforated core Core wrapped in stainless steel screen then encloded in fiberglass pillow Collector covered by large one-piece heat shield that is held in place with two clamps and stamped Cobra logo 4" muffler body capped with a 4" machined aluminum dual-cut tip that features small alluvial flutes Body arrives pre-set in slight upward position Works wtih stock or extended bags

New Silencer Design Featuring: Carbon Sleeve with Carbon Fiber End Cap and stainless steel exhaust tubing

K&N® High-Flow Air Filter™ designed to increase performance

Maintain momentum and use the torque of your motor without worrying about stalling

MOOSE RACING Water Pump Rebuild Kit 821328MSE Taillight and License Plate Holder with Turn Signal while allowing more airflow thanInclude every gasket, O ring, bearing and seal required to rebuild a water pump Typical kit includes the following: bearings where applicable; rubber seals; mechanical water pump seal where applicable; side cover gasket; water pump gasket; snap rings located on water pump shaft and copper drain washers